8
CRASH CYMBAL BOOM ARM ASSEMBLY
ITEMS REQUIRED:
1x Crash Cymbal (14”)
1x Crash Cymbal Boom Arm
1.
The cymbal stand is already assembled and only
requires height and leg adjustments. These can
be made by undoing the wing nuts, splaying the
legs, and then undoing both telescopic poles to
set to the desired height.
2.
At the top of the cymbal stand, there is an
adjustable bar. Loosen this to adjust the angle
the cymbal will sit, tighten this bar when you are
happy with the position.
3.
Remove the wingnut that holds the washer
and two felt pads. Remove these items leaving
behind a single felt pad on the stand. Place
the cymbal on this felt pad, then place the
remaining felt pad directly on top of it, followed
by the washer and wingnut. Do not overtighten,
this will reduce the resonance of the cymbal.
Summary of Contents for BDK STARTER KIT
Page 1: ...BDKSTARTERKIT SETUPGUIDE ...
