Gear4music JDD200, User Manual

FUNCTIONS

1.   POWER 

Used the switch the JDD200 off or on. A power 
supply needs to be connected to enable the 
module to work. Use the switch to select OFF  
or ON.

2.   DC 

Used to connect the included 9v power supply 
for providing power to the module. 
 
NOTE - only use the included power supply.

3.   USB 

Used for connecting to a computer for USB MIDI 
connectivity. 

4.   L/MONO 

Line out jack output, use a jack cable to connect 
to an amplifier, drum monitor, interface or PA 
system. Not suitable for headphones. Using one 
jack cable only in this output creates a mono 
output.

5.   R 

Line out jack output, when using two jack cables 
for stereo output, this will carry the right sided 
signal. Connect to a stereo amplifier, drum 
monitor, interface or PA system.

  6.     VOLUME 

Control for adjusting the volume on the  
drum kit.

  7.   SCREEN 

Used to display information from the module.

  8.   DATA 

Used to adjust settings within the drum kit after 
being selected by the individual buttons below.

  9.   KITS 

Used to scroll through and choose which of 
the 38 drum kit sounds you want to use. Press 
the KITS button and rotate the DATA wheel to 
select, the SCREEN will display which number 
kit is currently active. The SCREEN will show 
D.01 – D.38 to display this information.

10.   SONG 

Used to select one of the accompaniment 
songs that are built in to the drum kit. Press 
the SONG button to activate this mode, then 
use the DATA wheel to scroll through the 44 
choices. The SCREEN will show S.01 – S.44 to 
display this information. Use the PLAY/STOP 
button to start the song playing, pressing again 
to stop the song. An index of songs is available 
later in the manual. 

5

VOLUME

KIT

LINE IN

PLAY/STOP

SONG

TEMPO

CLICK

DATA

DC

USB

LINE OUT

L/MONO

R

JDD200

14

8

9

10

11

1

2

3

4

5

7

12

13

15

6