-4-
As shown in the above chart, in CF Mode (the bottom four LED lights keep flashing
quickly) No matter where the quadcopter locates(the blue light is the onward direction),
now the position of the remote controller is the rear of the quadcopter. At this time, push
the direction lever down, the aircraft will come back, and push the direction lever up,
the aircraft will fly far away.
★
push the left throttle stick to the lower right,and push the right throttle srick to the
lower right, the quadcopter stop flying.(picture 1)
Emergency stop
★
When the quadcopter suffers impact or external collision,quadcopter's direction will be
wrong. At this time, the quadcopter should be landed on the flat ground, to ensure the
front direction of the quadcopter(the red light is the onward direction) is consistent with
thetransmitter's. Push the left lever bottom left, and push the right lever bottom right
(two actions should be executed at the same time.) (picture 2)
Gyroscope calibration
★
Before start the aircraft,turning the throttle sticks
inwards to calibration.
After finishing the calibration, turning the throttle sticks
outwards to unlock.Propellers of quadcopter turn at low
speed,Pushing the throttle sticks,quadcopter flies up at
a lower speed
Unlock
★
Press the button of one key return,( the transmitter "Di"),the quadcopter will return
automatically. You can push the right lever up to correct the channel if deviation.
Press the button of one key return again( the transmitter "Di "),the quadcopter ends return
Or push the right lever up to end return
One key return
★
One key take-off: After finish the unlock, push the one key take-off button
the controller sends a "tick" sound,After finishing one key return,the quadcopter hover
about 1m height
★
One key landing: After the quadcopter flies, push one key landing button,
the controller sends a "tick" sound. After finishing one key landing, the quadcopter slowly
down to the ground, and stops turning.
One key take-off/landing
(picture 1)
(picture 2)
