WARNING
:
To avoid eye injury, do not stare directly into the light beam or shine
the beam directly into anyone’s eyes. This product is not designed, intended, or
recommended for children or hazardous environments.
CAUTION:
The flashlight may become warm or hot after extended periods of use
at the highest setting. Select a lower setting when the flashlight is hot. This is
typical for high-powered flashlights and does not cause damage to the flashlight.
AAA Battery Installation (See Warning)
1. Unfasten tail cap and remove battery holder.
2. Insert three (3) AAA batteries following
the correct polarity (+,-) marked on the
battery holder.
3. Insert the battery holder into the
flashlight with the positive (+) end first.
On/Off
•
To turn the flashlight on, press down firmly on the red power button located on
the tail of the flashlight until you hear a click.
• To turn the flashlight off, press down firmly again until you hear a click.
Twist Zoom
1. Hold both ends of the flashlight; gently twist clockwise to extend and focus.
2. Twist the opposite direction for a broad dispersed light beam.
Switching Modes
• There are 3 different lighting modes: HIGH, MEDIUM, LOW
• To switch through the 3 different lighting modes, gently press down on the
red power button.
• The flashlight will switch to the next mode when turned off and on in quick
succession. It will reset to high mode after being off for more than 10 seconds.
GETTING STARTED
OPERATIONS
WARNING:
Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a
reputable manufacturer. Do not mix different brands or types of batteries in the
same flashlight. Replace all batteries at the same time. Failure to follow safety
instructions may result in personal injury and damage to property.
POWERFUL
LED
LANYARD
TWIST ZOOM
DESIGN
ANTISLIP
BODY
RUBBER
O-RING
TAIL
CAP
POWER
BUTTON
AAA BATTERY
HOLDER
NEGATIVE POSITIVE
+ –
NEGATIVE POSITIVE
+ –
WARNING:
Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo,
Sony, Samsung, or LG. Remove the battery when the flashlight is not in use. The use
of other cell manufacturers or the failure to follow the battery manufacturer's safety
instructions may result in fire, explosion, personal injury, and damage to property.
18650 3.7v Lithium-ion Rechargeable Battery Installation (See Warning)
1. Insert one 18650 battery (Fig. 1) inside the 18650 clear battery tube (Fig. 2).
2. Insert the combined 18650 battery and clear tube into the flashlight with the
positive (+) end first.
Fig. 1
Fig. 2
+
18650
RECHARGEABLE
LITHIUM-ION BATTERY
-
HIGH
MEDIUM
LOW
