LOW
STROBE
SOS
WARNING
:
To avoid eye injury, do not stare directly into the light beam or shine the beam directly into
anyone’s eyes. Not to be used by children except under adult supervision.
CAUTION:
The headlamp may become warm or hot after extended periods of
use at the highest setting. Select a lower setting when the headlamp is hot.
WARNING:
Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a
reputable manufacturer. Do not mix different brands or types of batteries in the same
flashlight. Replace all batteries at the same time. Failure to follow safety instructions
may result in personal injury and damage to property.
AAA Battery Installation
1. Insert 3 AAA batteries following the correct
polarity (+,-) marked on the battery holder.
2. Close the battery compartment until the
latch clicks into place.
On/Off
To turn the headlamp on, press down firmly on the power button located on
the top of the headlamp until you hear a click.
To turn the headlamp off, press the power button again. If the headlamp has
been on for less than 5 seconds, press the power button to cycle through the
different modes until the headlamp turns off.
Switching Modes
There are 7 different lighting modes:
White Light Modes: Low, Medium, High, Strobe
Red Light Modes: Low, SOS, Strobe
To activate the white light modes, press the power button
until you hear a click. Press the power button again to cycle
through the 4 modes.
To activate the red light modes, press and hold the power
button for 3 seconds until the red light appears. Press the
power button again to cycle through the 3 modes.
To exit the red light mode, press and hold the power button
for 3 seconds until the white light appears.
If the battery is removed, the headlamp will reset to the
white light mode.
GETTING STARTED
OPERATION
ELASTIC
HEAD STRAP
BATTERY
COMPARTMENT LATCH
POWER
BUTTON
HEAD STRAP ADJUSTMENT
Attach the elastic head strap according to Fig. 1 and Fig. 2 below.
Adjust the length of the head strap to fit your head comfortably.
To loosen or tighten the head strap, simply slide the plastic strap adjuster
forward or backward.
Adjustable Light Angle (Fig. 3)
Tilt the headlamp down to adjust the beam angle and aim the light where it is
needed.
Fig. 3
Note:
To access the battery compartment, tilt the headlamp down and lift the latch.
Fig. 1
RED LED
WHITE LED
Fig. 2
LOW
MEDIUM
HIGH
STROBE
STRAP
ADJUSTERS
