11
If there is a short circuit in the cable, it will display as follows:
Push key (No) to exit calibration function. Push key
(Yes) to repeat measurement process.
Note: The calibration will recover the standard value of Class
UTP5 cable.
Start Up or Shut Down Hunting Function
1. Press “Push to test” key, the hunting indicator light (scan) will
flash, which indicates that audio frequency transmission of main
tester is activated. Insert the cable to be tested into the RJ45
SCAN port. Hold the receiver to trace the cable needed (the
usage of receiver is shown in the following). RJ11/BNC/USB
cable is located when inserted into its corresponding port.
Using the Receiver
Install a 9V battery. Press the “Push to Test” key, then approach
the cables with the probe. When the probe is near the target
cable, the problem will “beep” and the signal indicator light
“Power” will turn on. The louder the “beep” and brighter the
“Power” light indicates the closer you are to the targeted cable.
2. The user can turn the volume switch to control the volume in.
3. The Floodlight function helps users with operating low
light settings.
4. The earphone function helps avoid external interference in
noisy settings.
5. The test can not measure cable length and wire faults when it
is set to trace cable.
