Use of pressure relief device, on the discharge side of pump, is required to prevent damage from
pressure build-up, if the discharge is closed or blocked, while the power source is still running.
Do not
operate pump above recommended R.P.M.
Do not
pump at pressure higher than the maximum recommended for the pump
(see specifications).
Operate pump between 45
o
and 145
o
F liquid temperatures.
Make certain that the power source conforms to the requirements of your equipment.
Provide adequate protection in guarding around the moving parts, such as the shaft and pulleys.
Disconnect power before servicing.
Release all pressure within the system before servicing any component.
Drain all liquids from the system before servicing.
Secure the discharge lines before starting the pump. An unsecured discharge line may whip, causing
personal injury and/or property damage.
Check hoses for weak or worn condition before each use. Make certain that all connections are
tight and secure.
Periodically inspect the pump and the system components. Perform routine maintenance as
required (
see maintenance section
).
Do not
operate a gasoline engine in an enclosed area. Be sure the area is well ventilated.
Use only pipe, hose and fittings rated for maximum rated pressure of pump or pressure at
which pressure relief valve is set. Check with local supplier for proper pressure rating. (
Do not
use used pipe!)
Do not
use these pumps for pumping water or other liquids for human or animal consumption.
GENERAL SAFETY INFORMATION
Page 6
WARNING - Do not pump flammable or explosive fluids such as
gasoline, fuel oil, kerosene, etc. Do not use in explosive atmos-
pheres. The pump should be used only with liquids compatible with
the pump component materials. Failure to follow this warning may
result in personal injury and / or property damage and will void the
product warranty.
Summary of Contents for GDL200
