PRE-OPERATION CHECK
Page 4
D
Check tightness of all bolts and nuts.
D
Check gearbox oil level (Grade SAE80W-90 gear oil).
D
Grease all points, on all GHF mowers.
D
P.T.O. (power take-off) speed should not exceed shredder's rated RPM (revolutions per
minute).
D
Check correct length of P.T.O. shaft. When fitted, there should be 3
3
/
4
" free travel on
male and female tubing (check in fully raised and fully lowered positions).
D
The recommended cutting height, with the hammer or blade in its lowest position, is
between 2" and 4" (
Ref. 1
). Basically, the fine height adjustment is achieved with the top
link of the 3-point hitch. For a greater height adjustment, it is necessary to raise or lower
the roller (
Ref. 2
).
D
Drive belt should flex
3
/
8
" (1 cm.) when pushed firmly with the finger.
D
Shredder should be completely cleaned after use and before storage.
Summary of Contents for GHF100
