ADJUSTING THE SPREAD
11
The fertilizer spreading is regulated through the regulation lever that moves the opening section on the
bottom of the hopper.
In order to carry out the regulation, after having consulted the spreading table, according to the type of
product to spread and to the spreader speed, it is necessary to move the lever "A" along the graduated
scale "E" and blocking it in the chosen position with the pin "D".
In order to spread from both sides (ref. I), "A" and "B" levers must be in the same position, connected
through grip handle "C".
In order to carry out the spreading only through the left side (ref. II), it is necessary to disconnect the two
levers removing the "C" grip handle, to set the lever "A" in the chosen position, given by the spreading
chart, and to bring the lever "B" towards the higher part (position 1) in order to close the shutter of the
right side.
In order to spread only on the right side (ref. III) you have to move the lever "A" up, (in position 1) and
regulate the quantity to spread with the lever "B".
See this chart on the next page
Distribution on right side (ref. III)
Distribution on left side (ref. II)
Summary of Contents for PTP180-P
Page 14: ...SPREADING CHART 12...
Page 20: ...PARTS BREAKDOWN 18...
Page 21: ...PARTS BREAKDOWN 19...
