ATTENTION!!!
After you have made yourself familiar with the functions of the
appliance, please program your personal mastercode as well as a
pass code with which you replace the pass code which is located
on the memory place 00. Only by this your Cody Universal 2 is
protected against manipulation!
TIPTOMATIC:
The Cody Universal 2 has two potential free relay outputs enabling
direct control of a tubular drive or an industrial door drive unit or similar
instruments. After having entered a valid pass code
the user can,
within a period of 60 seconds, trigger the installed drive unit in the
dead man’s mode with the arrow keys UP
and DOWN .
The relay is activated only as long as the
arrow keys are pushed. The
two relays are interlocked against each other, so it is not possible that
both relays can be switched at the same time. After expiration of the of
60 seconds the Cody Universal 2 locks automatically. This function,
however, can be interrupted prior to the expiration of the 60 seconds,
by pressing the button.
Lock-out function:
If the lock-out function is activated, the Cody Universal 3 automatically
blocks any input for a set period after the input of a wrong pass code
which is signalled with a (3 beeps) sound signal.
You can freely program the lock-out time according to your
requriments.
The end of the lock-out time is signalled by a long sound signal.
General reset
General reset
Push reset button
on the PCB
> 5 sec.
Factory setting (default setting):
all memories erased (except 00)
mastercode = sequence 1-8
pass code 00 = sequence 1-4
Tiptomatic-time = 60 sec.
look-out time = 20 sec.
Put DIP switch 4 to
ON
Put DIP switch
back to OFF
All factory settings are restored by the general reset !
