geba GmbH
is released of its obligations regarding guarantee and product liability if – without prior
permission - the unit has been modified, or if the installation is unproper or not in accordance with our
instruction manual. The installer has to take care that the EMC-regulations are respected.
Interior mounting of the logic:
1. Put the screw-driver into the gap of the enclosure front, push the screw-driver up and
open the enclosure.
2. Remove the control PCB (which is force fitted to the inside of the enclosure).
3. Locate the screwed glands supplied (sealing nipple left side) in the
enclosure and replace the PCB. (Please ensure PCB is firmly in position)
4. Bore the fastening holes and fix the enclosure bracket at the wall.
5. The wires for the keyboard ensure through the left cable entry (sealing nipple), the wires
for the relay contact through the middle cable entry and the wires for the supply voltage ensure
through the right cable entry. Ensure tight seating of sealing nipple and cable gland, otherwise the
water-protection ot the appliance cannot be assured.
6. According to connection diagram connect the wires to the corresponding terminals:
Mounting instructions
The specific transmitter is now deleted!
RC transmitter
Program 2
Deleting of remote controls
Delete specific transmitter:
The taught-in transmitters are now all deleted !
Set DIP 1 to
ON
Press the button of the
RC transmitter
> 5 sec.
Put all DIP to OFF
Press the reset
button on the
logic board
> 5 sec.
Put
DIP 4 to ON
LED flashes
2x long
Delete all transmitters :
Put all DIP to OFF
Put
DIP 4 to ON
Set DIP 1 to
ON
