GeBe POWERMAN 8500 GR-ES, Manual

16

English

English

CONTROL

GENERATOR SWITCH

RECOIL STARTER

To start the engine, pull the starter grip lightly until 

resistance is felt, then pull briskly

NOTICE

Do not allow the starter grip to snap back against the 

engine. Return it gently to prevent damage to the 

starter.

FUEL VALVE

The fuel valve controls fuel flowing from the fuel tank 

to carburetor. Be sure to return the lever to “OFF” 

after stopping the engine.

CHOKE LEVER

The choke lever is used to provide an enriched fuel 

mixture when starting a cold engine. Slowly put the 

choke lever to “OPEN” position after the engine is 

started.

AC CIRCUIT BREAKER/OVERCURRENT 

PROTECTOR

The overload current will automatically switch off 

circuit breaker to avoid short circuiting of the load or 

overload. If the indicator of AC Overcurrent Protector 

is raised, the Overcurrent Protector is now in the 

“OFF” position. Press the button of AC Overcurrent 

Protector to the “ON” position again a few minute 

later.  If the circuit breaker is switched OFF 

automatically, switch the circuit breaker ON again.

GROUND TERMINAL

This ground terminal is dedicated to reliably 

grounding the whole generator.

OIL ALERT SYSTEM

The oil alert system is especially designed to 

prevent engine damage caused by an insufficient 

amount of oil in the crankcase. When the oil level 

in the crankcase fall down below the safe limit, the 

oil alert system will automatically shut down the 

engine(though the generator switch still remain 

in the ON position), so that the engine can’t be 

damaged due to the insufficient amount of oil.

GENERATOR OPERATION

Generator operation environment:

·  Temperature:-15°C - 40°C.

·  Humidity: below 95%.

·  Height above sea level: below 1,000m  

(If the area is over 1,000m high, the power should 

be lowered for operation).

CONNECTION TO THE HOUSEHOLD POWER 

SUPPLY

When connecting the generator to a household power 

supply, connection must be made by a qualified 

electrician. After connecting, carefully check electric 

connection for their safety and reliability, if not, 

damage to the generator,burning and firing may be 

caused.