8
Notice of Operating System Compliance
On-Lap 1503I supports Windows10/8.1/7 .
You can plug & touch on Windows 10/8.1/7
without any driver installation
Some revisions of Windows 8/8.1 before
2015/10/15 which requests for different
product code may not recognize 1503I.
Please upgrade your Windows, or email
Gechic for 1503I firmware change.
For Linux and Android developer, please
active ”HID multi-touch panels” while
establishing kernel, and the external touch
monitor can be supported. Or email Gechic
for Linux driver for setting in Linux/Android
system.
Chapter 5 Hot Keys, LED Light and OSD Instructions
Section 1 Hot Keys and LED Light Description
Notice: If need to adjust
“
Increase/up
”
or
“
Decrease/down
”
continuously , press the button and don't release. Do not press two buttons at the same
time, or it may cause no response or fault response.
LED Lights Description
:
It shows green light when turn on On-Lap Monitor and shows red light when stand by.
There is no light when the monitor is off.
Hot Keys Description
Power: Press the Power Button to power on/off the Monitor.
Exit: In the OSD panel, press the Exit Button to exit and back to the previous page.
Menu/Select: Press the Menu Button to launch OSD panel. In OSD panel, press this
button to select and enter the next page.
Increase Volume/UP: Press this Button to show "Volume bar." In the OSD menu, press this button to
move up or to the left. Press and hold this button to increase the volume continuously.
Decrease Volume/Down: Press this Button to show "Input Source." In the OSD menu, press this
button to move down or to the right. Press and hold this button to decrease the volume continuously.
If press both "Increase Volume/Down " and "Exit " at the same time, OSD will be reset as the factory
settings.
If press both " Increase Volume/Up " and "Decrease Volume/Down " at the same time, you can
enable "Mute" mode. Press these two buttons again to release mute mode.
Section 2 OSD Description
When turning on On-Lap monitor at the first time, the "Language Select" menu appears
on the left top. Please press " Menu/Select" button to choose the language you like,
then the "Language Select" menu won't appear next time. If press "Exit" button to
disable the "Language Select" menu, it will appear again when powering on the monitor
next time.
1. Basic Button Operation
Press button to launch the OSD panel. Press or to view the functions. To adjust
a certain function, press to launch it. If the selected function consists of sub-menu,
press or again to view the sub-menu. When the desired function is highlighted,
press to launch it. Press or to change the setting. To exit, press to exit. Repeat
the preceding steps to adjust other setting.