12
1
Water temperature
The temperature shown at the bottom of the screen shows
the current water temperature� Use the Up and Down
icon to set the desired temperature� The set point will
appear in blue� After 3 seconds without any change to the
set temperature value, the current water temperature will
reappear�
When the set value is lower than the current temperature
Cooling to xx�x will appear below� When the set value is
higher than the current temperature, Heating to xx�x will
be indicated under the value� Normally there is a short
delay before the heating starts, during which Heating
Suspended is indicated under the value�
Spa menu
From the home page you can access the following:
•
in�clear (if installed)
•
in�stream 2 (if installed)
•
spa menu
•
settings
To select an option, slide the left wheel up or down until
the desired icon menu is highlighted in the middle�
On the right side is a menu for access to the Display and
Contrast pages�
Keypad functions
Display page
Use this page to change the display orientation�
