SHENZHEN GETECH TECHNOLOGY CO,.LTD
51
http://www.geeetech.com/forum/viewtopic.php?f=13&t=17037
9.3 Motors can’t work
When your are testing the motors, if the motor of an axis has no response or can not work normally (the
extruder can work when it is above 170
℃
), you need check whether the motor, motor driven board or
voltage of this axis can work normally or not. Meanwhile you need make sure whether the bearing is
damaged or not, whether the smooth rod/screw rod is bent or not, whether the tension of belt is normal or
not, whether each axis is installed correctly or not. For detailed solutions, please refer to:
http://www.geeetech.com/forum/viewtopic.php?f=17&t=17038
9.4 Extruder can’t work/ extrusion not fluent
When you are testing the extruder, make sure the temperature is over 170
℃
. If you find that the extruder
doesn’t work or the extrusion is not fluent, or there is click noise, you need check the motor or clean the
barrel
and
nozzle
of
the
extruder.
For
detailed
method
please
refer
to
:
http://www.geeetech.com/forum/viewtopic.php?f=19&t=17097
9.5 Printing quality optimization
If there are problems such as stringing, warped edge, the first layer not sticking to the bed, and poor surface
quality, you can refer to following link to do adjustment for parameters:
http://www.geeetech.com/forum/viewtopic.php?f=26&t=17183
10. Specifications
Printing parameters
Printing technology: FDM
Build volume: 220*220*260 mm
³
Printing accuracy: 0.1mm
Summary of Contents for A10
