Basic use
8
To set either OGM1 or OGM2
1. Hold down
On/Off
for 2 seconds until you hear a
beep. If the red light’s on, OGM1 is set. If the red
light’s flashing, OGM2 is set. (OGM2 doesn’t let
the caller leave a message).
To switch the answering machine on or off
1. Press
On/Off
briefly. If the message display (‘00’
etc) is on, the machine is on and ready to answer. If
the message display is off, the machine is off.
♦
If the machine is off, it’ll answer calls after 15 rings
and play OGM2. (Most callers will hang up well
before 15 rings). This lets you ring in and switch the
machine on: see page 12.
To listen to your messages
The display shows the message total.
1. Press
Play
.
To pause, press
Memo
. To continue, press
Memo
again.
To skip to the next message, press
Skip
.
To skip to the previous message, press
Repeat
.
To erase a message, press
Erase
before it ends.
To erase all messages; after playing them, hold
down
Erase
until you hear a beep.
To stop, press
Stop
.
♦
Mailbox messages and memos are played last.
♦
An ‘erased’ message isn’t erase immediately. It’s
erased after the machine says ‘end of messages’.
Up until this time you can still hear an ‘erased’
message again.
♦
To hear only the new messages, not the old ones,
hold down
Play
until you hear a beep.
♦
Don’t let the memory become full - erase the
messages you don’t need to keep.
♦
The longest message the machine accepts is 2
minutes. It’ll send the caller a warning beep just
before time.
Tones or end of call signals after message
playback
On some systems, particularly cable telephone
networks, you may hear short periods of tone
or ‘end of call’ announcements after playing
back messages. This can be quite normal but
if it is a cause for concern, please contact your
local telephone service provider who may be
able to make an adjustment to your particular
telephone line.