16
IP CONFIGURATION
Configuring the IP Address
The
8x8 DVI DL Matrix
supports IP-based control using Telnet or the built-in
Web-based GUI. To set up IP control, the network settings for the
8x8 DVI DL
Matrix
must be configured via RS-232. The default network settings for the
matrix are as follows:
IP Address:
192.168.1.72
Subnet:
255.255.255.0
Gateway:
192.168.1.254
HTTP Port:
80
Telnet Port:
23
1.
Connect an RS-232 cable from the PC to the
8x8 DVI DL Matrix
.
2.
Launch a terminal emulation program (e.g. HyperTerminal) and use the
following settings:
Baud Rate:
19200
Data Bits:
8
Parity: None
Stop Bits:
1
Flow Control:
None
3.
Set the IP address for the matrix using the
#sipadd
command (see page
34 for details).
4.
Set the subnet mask using the
#snetmask
command (see page 35 for
details).
5.
Set the gateway (router) IP address using the
#sgateway
command
(see page 32 for details).
6.
Set the Telnet listening port using the
#set_telnet_port
command
(see page 31 for details).
7.
Set the HTTP listening port using the
#set_http_port
command
(see page 30 for details).
8.
Power-cycle the matrix to reboot and complete all IP setting changes.
9.
Type the IP address that was specified in step 3, in a Web browser to access
the Web interface or use the same IP address to Telnet to the matrix.
NOTE:
Depending upon the network, the IP address, subnet mask,
gateway IP, Telnet port, and HTTP port will need to be set. Consult
your network administrator to obtain the proper settings.
Summary of Contents for GEF-DVI-848DL
