7
MATRIX DESCRIPTIONS
Back
9
IP Control
Connect an Ethernet cable to this port to control the
8x8 Matrix for HDMI w/8 ELR-POL
Outputs
using IP Control. See page 33 for more information on configuring the matrix for
IP control.
10 RS-232
Connect an RS-232 cable from this DB-9 connector to the RS-232 control device. See
page 32 for more information.
11 IR Out (All)
Connect an IR emitter to this jack (Gefen part no. EXT-2IREMIT).
12 IR In (All)
Connect a 3.5mm-to-3.5mm mini-mono cable between this IR jack and the Gefen PACS
or Gefen Mini PACS. IR Emitters or IR Extenders will not function if connected to this jack.
13 USB
Service port for manufacturer use only.
14 IR Out (A - H)
Connect an IR Emitter (Gefen part no. EXT-2IREMIT) cable from each of these jacks and
each source device.
15 IR In (A - H)
Connect a 3.5mm-to-3.5mm mini-mono cable between each of these IR jacks and
the Gefen PACS or Gefen Mini PACS. IR Emitters or IR Extenders will not function if
connected to this jack.
16 ELR-POL Outputs (A - H)
Connect a CAT-5e (or better) cable from each of these jacks to the ELR-POL In jacks on
the ELR-POL Receiver units.
17 HDMI Inputs (1 - 8)
Connect a Hi-Def source to each of these ports using HDMI cables.
18 HDMI Locking Connector
Used to lock the HDMI cable in place.
19 Power Switch
Turn the power ON or OFF using this switch.
20 110/220 AC Power Receptacle
Connect the included AC power cord to this receptacle and connect the plug to an
available electrical outlet.
