page | 127
Upgrading using USB
1. Download the firmware update from the Support section of the Gefen Web site.
2. Power-ON the 16x16 Modular Matrix for HDMI w/ HDCP.
3. Connect a USB cable between the computer and the 16x16 Modular Matrix
for HDMI w/ HDCP.
It is unnecessary to disconnect any cables or extenders from the 16x16 Modular
Matrix for HDMI w/ HDCP
during the update process.
4. Once the computer is able to connect to the 16x16 Modular Matrix for HDMI w/ HDCP,
a Removable disk icon will be displayed under My Computer.
5. Extract the firmware file from the .ZIP file and drag the .bin file to the Removable Disk.
6. Disconnect the USB cable from the computer.
7. The matrix will verify the firmware content. The front-panel display will show
the following if the firmware passes.
8. After the firmware file integrity has been verified, the matrix will begin the upgrade
procedure. The upgrade progress will be displayed in the front-panel display.
9. After the matrix has been updated, the unit will automatically initiate a countdown to
reboot. The
Power
button can be pressed to bypass the countdown without harming
the upgrade process.
10. After the matrix reboots, the firmware upgrade process will be complete.
content check:
pass
IMPORTANT:
DO NOT
power-off or disconnect the AC power cord
from the matrix, at any time, during the firmware upgrade process.
-F/W UPDATE-
35
%
FINISHED
REBOOT IN 52 SEC
Appendix
Firmware Upgrade Procedure
