The 16x16 Modular Matrix for HDMI w/ HDCP provides IR control. Controlling IR through
the matrix can be accomplished using an IP-based automation control device. Refer to the
user documentation that came with your product for details.
Controlling the Display from the Source Location
1. Connect a 3.5mm-to-3.5mm mini-mono cable from one of the electrical IR emitter jacks,
on the automation system, to the
IR IN
jack on the 16x16 Modular Matrix for HDMI
w/ HDCP.
2. Connect an IR emitter from the
IR Out
jack on the Receiver unit to IR sensor on
the display.
page | 37
Operating the 16x16 Modular Matrix for HDMI w/ HDCP
Using Bidirectional IR
Automation System
HDMI cable
HDMI cable
Receiver unit
Matrix
3.5mm-to-3.5mm mini-mono cable
CAT-5
To source
IR emitter
Electrical signals
