page | 29
Advanced Operation
RS-232 Commands
#autolock
The
#autolock
command enables or disables the Genlock mode. The factory-default
setting is 0 (disable).
Syntax
:
#autolock param1
Parameters
:
param1
Aspect ratio
[0 ... 1]
Value
Description
0
Disable
1
Enable
#blacklev
The
#blacklev
command sets the black level of the output signal. This is the equivalent
of adjusting the RGB/Y Output Offset using the OSD. Refer to the
Picture Menu
for more
information.
Syntax
:
#blacklev param1
Parameters
:
param1
Level
[0
...
1023]
