page | 52
The
HDMI and DVI to 3GSDI Scaler
contains a fuse as part of the internal power supply.
This fuse can easily be replaced by using the following steps.
1.
Disconnect the power AC power cord from the IEC connector on the scaler.
2.
Locate the fuse door, between the IEC connect and the power switch, on the back
of the unit.
3.
Use a small flat-head screwdriver to gently pry the locking mechanism, on the fuse
door, from the scaler.
4. Remove the fuse door.
Appendix
Fuse Replacement
STOP:
Before installing modules and prevent the risk of possible
electrical shock, unplug the AC power cord from back of the scaler.
