7
1
RS-232 Serial Communications Input
This port is capable of 2-way serial communication between RS-232 devices
connected to the sender and receiver. This port can be connected to a
computer’s serial communications port for interaction with a RS-232 serial
communications device connected to the receiver.
2 DVI-D
Output
This receptacle will accept a DVI capable Single-Link output device.
3
Infrared (IR) Receiver
This IR receiver will relay IR commands from the receiving unit to the sending
unit for output to a IR transmitter (blaster) on a IR controllable device.
4
LED Power Indicator
This LED will become active once the included 5V DC power supply is properly
connected between the receiver and an open wall power socket.
5
Locking 5V DC Power Input
Connect the included 5V DC power supply to this input. The Power LED will
become active when the 5V DC power supply has been properly connected
to the unit and an open wall power socket. This receptacle features a locking
connector for a secure connection.
6
Infrared (IR) Receiver Extension Port
This port will accept an optionally purchased IR extension cable (Gefen part#
EXT-RMT-EXTIR). This is useful for installations where the IR receiver, located
on the front panel (Item 2 on this page), is not in line-of-sight with the IR remote
control used to relay commands to the device at the sender’s location.
7
Fiber Optic Connector (Multi-Mode SC Type)
This connector accepts 1 strand of SC terminated fi ber optic cable that will link
the sending and receiving unit together. The DVI RS-232 over Fiber system will
only accept multi-mode fi ber optic cabling.
8
RJ-45 Link Connector
This port is used to connect the sending and receiving units together for data
traffi c. Use a CAT-5, CAT-5e or CAT-6 cable. When fi eld terminating cable
please adhere to the TIA/EIA-568-B specifi cation (page 9).
RECEIVER PANEL DESCRIPTIONS
