INFRARED REMOTE FUNCTIONS
4
Starting with version 0.96, the infrared remote functions are disabled at boot time. You
must press ENT,4,5,6 to enable them. This is a list of all the functions that are available
on the HDVI-10 using a standard Sony Infrared Remote Control:
· Input Select “TV/VIDEO”: Switches between SDI input A and input B. This feature is
available only with the dual-input HDVI-10-2.
· Set Pass Through Mode “RECALL” or “JUMP”: Toggles the HDVI-10 to Pass Through
ON, Frame Rate Only and OFF. Default is OFF.
· Set Color Mode “0”: Toggles the color mode between RGB 0-255, RGB 16-235, Blue
only and Blue only Bright. The default is RGB 0-255.
· Set Output Mode “1”: Toggles the output mode between: Auto, 1024x768, 1280x720,
1280x768, 1280x800 and 1280x1024.
· Save Current Settings to Flash “ENT,1,2,3”: Saves the current settings to flash.
When you press ENT, the HDVI-10 will not accept any of the remote commands
described above until you press 3 more buttons. If the combination you press is different
than 1,2,3, the save
operation
to flash
memory
will be aborted.
When you are done using the remote, you can disable its funct
ionality
by pressing
“ENT, 4,5,6"