1003
9
Geha top secret 120
english
Paper jam
You have fed in too much paper.
NOTICE!
Do not press rocker switch alter-
nately forwards/backwards (
-
).
Cutting unit could be damaged.
• Press rocker switch
.
Pa per is pus hed out.
• Se pa ra te pa per stack.
• Press rocker switch
.
• Feed in pa per successively.
Shredded material container full
NOTICE!
Empty the cut material container,
immediately because if it is too full,
malfunctions can occur in the cutting
system.
• Press automatic start stop control for
2 sec.
• Switch equipment off. To do this tap
rocker switch
.
• Move cutting head away.
• Empty cut material container.
• Remove cutting head.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 15 to
20 minutes before using it again.
5 Troubleshooting
Switch off the shredder and pull out the mains
plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
Oil the cutting unit when
cutting performance
decreases or the device
becomes noisy, or every
time you empty the waste
container (Cross cut only):
• Spray special cutting block oil through paper
feed opening across the whole width of the
cutting system blades.
• Press automatic start stop control and run
cutting system forwards and backwards
(
-
) several times without feeding paper.
Paper dust and particles are shaken off.
6 Cleaning and maintenance
Summary of Contents for top secret 120
