3–50
AP0902
Operation
Taking an attachment off the quick
hitch facility
WARNING!
To avoid injury, the attachment must be placed on the ground so that it will not
fall over when removed
☞
Position the attachment so that after removal it will stand safely and will not
tip over.
☞
Take the attachment off the quick hitch facility as follows:
•
Drive the machine with empty attachment up to the storage location.
•
Roll back the quick hitch facility (
). To do this:
Push lever 21 to the left (A)
•
Lower the loader (
) until the attachment is about 2 – 4 in (5-10 cm) above the
ground. To do this:
Push lever 21 forward (C)
Attachments with hydraulic function:
•
Switch off the engine
•
Change round the hydraulic connections (figure 89) from the attachment to the lock
cylinder, in accordance with the operator’s manual of the attachment
•
Release the lock on the quick hitch facility. To do this:
Keep tip switch 54 in position A depressed and simultaneously
•
Retract the lock pin of the quick hitch facility. To do this:
Push lever forward 88/22 forward (88/E)
•
Tilt quick hitch facility slightly forward (
). To do this:
Push lever 21 to the right (B)
•
Lower the bucket fully (
). To do this:
Push lever 21 forward (C)
21
Fig. 88: Lowering and tilting in the attachment
22
Fig. 89: Changing round the hydraulic connections
Fig. 90: Unlocks the quick hitch facility
54
B
A
Fig. 91: Taking off the attachment
21
22
Summary of Contents for 418T Wheel
