913225/CP0807
84
PRINTED IN U.S.A.
- Bring the carriage under the locking tube of the
attachment, slightly lift the boom, and tilt the car-
riage rearward to position the attachment (fig. C).
- Lift the attachment off the ground to ease locking.
HYDRAULIC LOCKING AND CONNECTING THE
ATTACHMENT
- Place the selector valve in position A (fig. D), with
the hydraulic circuit for the attachment locked open.
- Press button (1) (fig. E) on the hydraulic control
valve joystick to lock the attachment on the carriage.
- Stop the engine, but keep the ignition “on.”
- Relieve the pressure from the attachment hydraulic
circuit by pressing buttons (1) and (2) (fig. E) on the
hydraulic control valve joystick four or more times.
- Connect the quick-connectors as needed for the
attachment’s hydraulic movements.
IMPORTANT:
Make sure that the quick-connec-
tors are clean, and protect the connections that
are not used with the caps provided.
- Close the selector valve in position B (fig. D), with
the hydraulic circuit for the attachment locking
“closed.”
HYDRAULIC RELEASING AND DISCONNECT-
ING THE ATTACHMENT
- Close the attachment.
- Place the selector valve in position A (fig. D), with
the hydraulic circuit for the attachment locked
“open.”
- Press button (2) (fig. E) of the hydraulic control
valve joystick to release the attachment.
- Stop the engine, but keep the ignition “on.”
- Relieve the pressure from the attachment hydraulic
circuit by pressing buttons (1) and (2) (fig. E) on the
hydraulic control valve joystick four or more times.
- Disconnect the quick-connectors of the attachment.
IMPORTANT:
Make sure that the quick-connec-
tors are clean, and protect the connections that
are not used with the caps provided.
REMOVING AN ATTACHMENT
- Proceed in the reverse order of paragraph
INSTALLING AN ATTACHMENT.
- Be sure to place the attachment flat on the ground
and in its closed position.
G - HYDRAULIC ATTACHMENT, WITH
MANUAL LOCKING DEVICE
With Tri-Function Joystick
INSTALLING AN ATTACHMENT
- Ensure that the attachment is in a position for lock-
ing it to the carriage. If it is not correctly oriented,
take the necessary precautions to safely position it.
- Check that the locking pin and the clip are in posi-
tion in the bracket (fig. A).
- Park the telescopic handler with the boom lowered
in front of and in line with the attachment. Tilt the
carriage forwards (fig. B).
- Bring the carriage under the mounting tube of the
attachment, slightly lift the boom, and tilt the car-
riage rearward to position the attachment (fig. C).
C
E
1
2
D
B
A
WARNING
Always close the valve to position B (fig. D)
after locking on the attachment, to avoid acci-
dental unlocking, and to use the attachment
safely.
A
