50950106/AP0313
37
Note:
The engine cannot be started unless the operator is sitting in the seat and
the restraint bar is lowered.
7.
Power-A-Tach
®
System Switch
– A three-position momentary rocker switch
is used to actuate the Power-A-Tach® System. Press the top of the switch to
retract (release) the hitch pins; press the bottom of the switch to extend
(engage) the hitch pins and activate the warming circuit. Set the switch to the
neutral position (middle) to turn off the warming circuit (see page 26).
8.
Engine Speed Control
– Controls the engine speed. Move the control clock-
wise to increase and counter-clockwise to decrease the engine speed.
Joystick Controls
The loader may be equipped
with dual joystick controls,
(Figure 14). The left joystick
controls the drive, and the right
joystick controls the lift/tilt.
Drive Controls
Forward, reverse, speed and
turning maneuvers are accom-
plished by movement of the left
joystick. To go
forward
, push
the drive control forward; for
reverse
, pull the control rear-
ward. To turn
right
, push the
control right; to turn
left
, push
the control left. To go
forward
and left
, move the control for-
ward and left. To go
forward
and right
, move the control forward and right. To move
back and left
, move the
control back and to the right. To move
back and right
, move the control back
and to the left.
Be sure the joystick controls are in neutral
before starting the engine. Operate the con-
trols gradually and smoothly. Excessive speed and quick control
movements without regard for conditions and circumstances are
hazardous and could cause an accident.
Moving the joystick farther from neutral increases the speed steadily to the max-
imum travel speed. Tractive effort decreases as speed increases. For maximum
tractive effort, move the joystick only slightly away from the neutral position.
The engine may stall if the control is moved too far forward when loading the
bucket.
Figure 14 Dual Joystick Controls
1. Lift/Tilt Control
2. Drive Control
1
2
WARNING
Summary of Contents for R190
