917387/BP0310
7
During Operation
¾
Machine stability is affected by: load being carried, height of the load,
machine speed, abrupt control movements and driving over uneven terrain.
DISREGARDING ANY OF THESE FACTORS CAN CAUSE THE
LOADER TO TIP, THROWING THE OPERATOR OUT OF THE
SEAT OR LOADER, RESULTING IN DEATH OR SERIOUS INJURY.
Therefore: ALWAYS operate with the seatbelt fastened and the restraint bar
lowered. Do not exceed the machine’s Rated Operating Capacity. Carry the
load low. Move the controls smoothly and gradually, and operate at speeds
appropriate for the conditions.
¾
When operating on inclines or ramps, always travel with the heavier end of
the loader toward the top of the incline for additional stability.
¾
Do not raise or drop a loaded bucket or fork suddenly. Abrupt movements
under load can cause serious instability.
¾
Never activate the float function with the bucket or attachment loaded or
raised, because this will cause the lift arm to lower rapidly.
¾
Do not drive too close to an excavation or ditch; be sure that the surrounding
ground has adequate strength to support the weight of the loader and the load.
¾
Never carry riders. Do not allow others to ride on the machine or attachments,
because they could fall or cause an accident.
¾
Always look to the rear before backing up the skid-steer loader.
¾
Operate the controls only from the operator’s seat.
¾
Always keep hands and feet inside the operator’s compartment while oper-
ating the machine.
¾
New operators must operate the loader in an open area away from bystanders.
Practice with the controls until the loader can be operated safely and
efficiently.
¾
Wear safety goggles and head protection while operating the machine. Oper-
ator must wear protective clothing when appropriate.
¾
Exhaust fumes can kill. Do not operate this machine in an enclosed area
unless there is adequate ventilation.
¾
When parking the machine and before leaving the seat, check the restraint bar
for proper operation. The restraint bar, when raised, deactivates the lift/tilt
control and auxiliary hydraulics, and applies the parking brake.
Maintenance
¾
Never attempt to by-pass the key switch to start the engine. Use only the
jump-starting procedure detailed in the
Operation
chapter of this manual.
¾
Never use your hands to search for hydraulic fluid leaks. Instead, use a piece
of paper or cardboard. Escaping fluid under pressure can be invisible and can
penetrate the skin and cause serious injury. If any fluid is injected into your
skin, see a doctor at once. Injected fluid must be surgically removed by a
doctor or gangrene may result.
Summary of Contents for V270
