5
www.geiger.de
EN
EN
f
Only use connecting cables that are suitable with the environmental conditions and
which meet the construction requirements. (see accessories catalogue)
f
If the device is not equipped with a connecting cable and a plug, or other means for
disconnecting from the mains with a contact opening on each pole according to the
conditions of the overvoltage category III for full disconnection, a disconnecting
device of this type must be incorporated into the permanently installed electrical
installation according to the wiring rules.
f
Do not mount the connecting cables near hot surfaces.
f
A plug for the disconnection of the motor from the power supply must be accessible
after installation.
f
Damaged connecting cables must be replaced by GEIGER connecting cables of the
same type.
f
The device must be mounted as described in the installation instructions.
f
Parts that are inserted must be correctly positioned or locked in place.
f
Screw fastenings must be sufficiently tight. Make sure that the screw length is correct
so that the parts behind it are not damaged.
f
For the required stability, all specified parts must be installed.
f
Fixations shall not be made with adhesives since they are regarded as unreliable.
