6
Gerhard Geiger GmbH & Co. KG | 100W1590
0519
V001
en
EN
EN
7. Assembly note
Since the RESCUEline is exclusively powered by the battery, the electronic control
unit must be supplied with mains voltage during installation. If the control unit is not
connected to the mains after installation, the battery may be deeply discharged.(See
operating mode: deep discharge state, point 11).
The GEIGER RESCUEline has been designed as a battery-powered emergency system espe-
cially for the 2nd escape route. The 2nd escape route leads through an emergency exit which
serves as access for emergency services into the building.
However, as there is no standardized regulation in Europe, the respective country regulations
must be observed. The use of the GJ5606AE100 must be approved by your local fire and
rescue authorities.
The system consists of a Venetian blind motor, an electronic control unit with limit stop switch
and a LED display that shows the system status at any time over colour LEDs.
The system can be connected to a central fire alarm system.
In case of fire or in the event of an error case the electronic control ensures the immediate
opening of the blind in order to clear the emergency exits. The system is independent of the
supply voltage in the event of fire, failure or tests.
When viewed from inside the room, the
electronic system of the GJ5606AE100 is
located on the left side together with the
limit stop switch.
The electronic control is also available for
right-hand installation, so that it is on the
right side viewed from the inside of the
room.
The blind stripes are wound up from the
outside on the winding rolls.
The GJ5606 AE100 must be in alignment
with the turner bars.
The GJ5606 AE100 must be installed
centrally. Make sure that you have a
uniform load distribution.
230
V~/50
Hz
Central fire alarm
system
LED display
Control switch
Electronic system
Drive
Electric mains
Inside the room
Direction
OPEN
