Rev. 01 08/20
30
Operation
OptiFlex Pro BN
much powder
little powder
Adjust the powder output volume (e.g. according to the desired
coating thickness)
– Factory default setting of 50% is recommended for initial
operation. The total air volume is thereby kept constant
automatically by the control unit.
To achieve maximum efficiency, we recommend avoided an
overly high powder volume where possible!
2.
Check fluidization of the powder in the powder container
3.
Point the gun into the booth, switch the gun on and visually check
the powder output
Setting the electrode rinsing air
1.
Press the
key.
The second display level will be shown.
2.
Adjust the correct electrode rinsing air according to the applied
nozzles (deflector plate, flat jet nozzle)
≈ 0.1 Nm³/h
≈ 0.5 Nm³/h
too much electrode rinsing air
3.
If in this display level is no operation for 3 seconds, the first display
level is switched over independently.
Summary of Contents for OptiFlex Pro BN
