Rev. 00 03/19
30
Operation
OptiFlex Pro F Spray
of the powder hopper; otherwise the fluidized powder can
escape from the cover.
– Close the filling cover of the powder hopper again.
4.
Set coating parameters:
Select predefined operating mode (Preset mode)
1.
Turn on the gun control unit with the
ON
key
2.
Press the corresponding application key.
The arrow above the desired button lights up.
The pre-defined application modes have preset values for high
voltage and spray current:
Application mode
Preset µA
Preset kV
flat parts
100
100
complicated parts
22
100
overcoat
10
100
3.
The air values for total air, powder output and electrode rinsing air
can be individually defined and are saved in the programs.
Starting the individual adjustable programs
1.
Turn on the gun control unit with the
ON
key
2.
Press the
program key
3.
Select the desired program (01-20)
Program 20 active
4.
Change the coating parameters as required
Programs 01-20 are preset at the factory but can be modified at
any time, after which they are automatically stored.
Summary of Contents for OptiFlex Pro F
