Rev. 01 08/16
OptiSelect GM03
Operation
23
Operation
WARNING
Holding the gun incorrectly
During the coating process, the gun can discharge along the body
of the coater if not held using its intended handle, which has been
grounded.
► Always hold gun only by the handle!
► Do not touch any other parts of the gun!
Bedienung
Operation
Setting powder output and powder cloud
The powder output depends on the selected powder output (in %), and
the powder cloud on the selected total air volume.
As a factory default value, a powder rate of 50% and a total air
volume of 4 Nm³/h are recommended.
– If values are entered that the gun control unit cannot implement,
then the operator is informed of this by a blinking in the relevant
display and a temporary error message!
Setting the total air volume
1.
Adjust the total air volume on the gun control unit with the
T3/T4
keys
–
Adjust the total air volume according to the corresponding coating
requests