Rev. 01 08/16
OptiSelect GM03
Operation
25
Adjust the correct electrode rinsing air according to the applied
nozzles (deflector plate, flat jet nozzle)
≈ 0,1 Nm³/h
≈ 0,5 Nm³/h
too much electrode rinsing air
3.
If in this display level is no operation for 3 seconds, the first display
level is switched over independently.
Rinsing mode
The rinsing mode enables blowing off powder accumulations in the
powder hose.
Activating the rinsing function
Manual equipment without optional PowerClean module
(system parameter P01=0)
The rinsing mode can only be activated from standby mode (main menu
display, no powder conveying).
On OptiFlex 2 F Manual coating equipment, the injector must be
disconnected prior to cleaning procedure, on OptiFlex 2 B, the
suction unit must be lifted, and on OptiFlex 2 S, the powder
container must be empty.
1.
Detach the injector
2.
or
