Rev. 01 08/16
OptiSelect GM03
Operation
27
2.
START =
Procedure
Effect
Automatic
(automatic)
– The rinsing process is started
– Injector, powder hose, gun and spray nozzle
are purged using compressed air
– The PowerClean function enables parallel
cleaning of other components, such as the
fluid intake unit, powder container, etc.
– The rinsing mode is exited if the automatic
rinsing sequence has finished.
Manual
(manual)
The operator controls the number and length of the
PowerClean impulse by pressing the gun trigger a
second time
3.
STOP =
or
or
the cleaning mode is terminated automatically.
After completion of the PowerClean procedure, the controller switches
back to coating mode.
Activate/deactivate the program change function via
remote control
The remote control function has been set in the factory to change the
powder output.
If the operator prefers the possibility to switch between the programs, this
function is to be activated/deactivated on the control unit.
Activate/deactivate the program change function
on the gun control unit
1.
Hold
key pressed
2.
Press the
key
– The display flashes once, and the program change function is
activated/deactivated
