Document Reader AT10K User Guide
Installing the Reader
Page 18 of 29
To reduce the risk associated with hazardous voltage which, if not avoided,
could result in death or serious injury:
Do not use the reader with any AC power supply other than the
provided Gemalto AC power supply.
3. Connect the USB cable:
I.
Insert the Type B connector into the USB port located on the back of the reader.
II. Insert the Type A connector into a USB port on the host PC.
4. If you want to attach peripheral USB devices to the reader, you will need to connect the power
supply (if you are using the reader as-is, you can skip this step). To connect the power supply:
I.
Connect the connector from the power supply to the power connector at the rear of the
reader.
Do not force.
There is only one orientation that will allow the cable to be connected
to the power port.
II. Connect the AC cable to a functioning power outlet.
5. Turn the reader on using the rocker switch.
6. A power-on self-test occurs automatically during power up. If the reader is installed correctly and is
operational, the indicator light should illuminate the green tick. If another LED shows then consult
page 14 on LED status.
Test the reader installation
After installing the reader, perform a quick test to ensure the reader is functioning properly and the
software was installed correctly.
To test the reader:
1.
Start the application
Page Reader Expo
from the shortcut created during software installation.
2.
Select a scheme that matches your reader. If you are unsure, select the “
ePassport and Images
”
scheme.