Cinterion
®
ENS22-E AT Command Set
9.2 AT+CMGC
ENS22-E_ATC_V01.000
19/02/11
Page 145 of 189
9.2
AT+CMGC Send SMS Command
Syntax
Notes
• After invoking the commands
, it is necessary to wait for the prompt ">" before entering
PDU.
• In general but especially at baudrates below 19200, it is recommended to only use the command line termi-
nation character (
) before starting PDU input. Use of line termination character followed by an additional
response formatting character (
) may cause the problem that the latter will become part of the input data.
• The
value ranges from 8 to 174.
Test Command
AT+CMGC=?
Response(s)
OK
Write Command
PDU mode
AT+CMGC=
<CR> PDU can be entered <CTRL-Z>/<ESC>
Response(s)
+CMGC:
]
OK
If sending fails
ERROR
+CMS ERROR:
<err>
PIN Last
Reference(s)
+
-
3GPP TS 27.005