Page 13
In ePassport models, the front fascia should be plastic or a non-metallic material
In ePassport models, do not allow a metallic surface under and parallel to the document
tray
Allow sufficient clearance above the document window for the user to hold the document
down on the document window
The document window must be shielded as much as possible from direct lighting
(reference mechanical drawing DT-01823), and any surfaces directly above the document
window must be matte black. Failure to observe this may cause unreliable document
detection.
Figure 11: Mounting - Recommended
Figure 12: Mounting - Not Recommended
Note:
The reader should be inclined 5° to 10° to prevent liquid from entering the kiosk and to
discourage its use as a shelf.
Connecting the Power Supply
The reader is designed to be powered from a switched, UL-listed power source supplied with the
kiosk and terminating in a suitable DIN connector. The reader is supplied with a power cable and
power supply but does not have a power switch.
Connect the DIN connector from the power supply to the power connector at the rear of the
reader, and secure or tie-off the cable as required.
Note:
If you choose to use your own power supply, it must be a UL-listed device. Contact your
sales representative or Gemalto Global Technical Services (GTS) for details.
Connecting to the Host System
The reader is supplied with a 2-meter USB A-B communication cable.
