7
SIS-PM / SiS-PM-841 / SIS-PMS User Manual
8.
Switching SiS-PM(S) on and off,
connection to the managing computer
•
The SiS-PM(S) should be switched on and off by means of the main rocker
switch.(Red Plastic switch)
•
To protect electrical installations from possible high current and short circuit the SiS-
PM(S) is equipped with the automatic circuit breaker;
•
The power voltage for the manageable part of SiS-PM(S) is derived from the USB
port of the managing computer, (or when the USB cable is disconnected, from the
external power adapter for the SiS-PM and from the build in power adapter for the
SiS-PMS).
•
If the SiS-PM(S) is switched on then the red indicator “POWER” is lit up. In this case
both sockets marked with
are now “live” and connected to the power supply;
•
The manageable sockets of SiS-PM(S) (marked with Socket numbers) can be
connected to or disconnected from the power supply depending on the computer’s
initiated or preprogrammed events. The current status of each manageable socket is
represented by the corresponding indicator. E.g. Red lamp will be lit if socket has
power to it.
•
SiS-PM-841 sockets can be controlled by PC and by other external device which can
support PM-interface, in particular – CAS-441-PM, CAS-841-PM. Supervisory external
device can read status(*) of the controlled socket. For detailed information please
refer to the user’s manual of the connected device.
•
The moment the SiS-PM(S) is connected to the working computer via the USB cable
an audible beep will be heard indicating that the SiS-PM(S) is operating correctly;
•
If you want the hardware event schedule to work with the manageable computer
switched off, the optional power adapter 9VDC 0,5A should be connected to one of
the sockets marked with the sign
, (or into a wall socket),and its VDC
connector should be connected to the corresponding 9VDC of the SiS-PM.
SiS-PMS contains the build in power adapter.
•
Install enclosed software Gembird Power Manager.
•
Further follow the software guide instructions (see below).
* Status – means voltage present on the controlled socket.
9. Software installation
a.
Insert CD with the software into the computers CD-ROM drive;
b.
If for any reason the automatic setup does not work, then open the CD-ROM drive
in the My computer window and launch SETUP.EXE from the CD;
c.
Follow instructions of the installation software;