6.0 - HOW TO PROGRAM A NEW KEY
1. Switch the system OFF.
2. Connect the BLACK wire marked HW to the vehicle ground.
3. Turn ignition key “ON” and then “OFF”.
4. Insert the new electronic key in its receptacle. The LED will flash once to
confirm learning.
5. Repeat steps 3 and 4 for each new key to be learned.
If the immobilizer is connected to an alarm system, repeat procedure from step
3 and press the remote control button; the LED will flash to confirm learning.
NB: The unit can learn up to 12 electronic keys when in disarm mode.
7.0 - ELECTRICAL CONNECTIONS
.
Disconnect the negative battery terminal and only re-connect after the
installation is completed
GROUND
BATTERY POSITIVE TERMINAL
IMMOBILISATION RELAY 1
IGNITION
DOOR SWITCH
NEGATIVE OUTPUT WITH SYSTEM
ARMED AND +15/54 ACTIVATED
IMMOBILISATION RELAY 2
WIRE TO PROGRAM NEW KEY
BLACK marked
BLACK marked “R”
2x BLACK marked “B”
2x BLACK marked “B1”
2x BLACK markned “H”
2x BLACK marked “H1”
BLACK marked “G”
BLACK marked “VM”
BLACK marked “HW”
BLACK marked “SN”
“M”
4.0 - ARMING
5.0 - DISARMING
The 5079T immobilizer passively arms:
5 minutes after the engine is switched OFF and no door is opened.
Approx. 30 seconds after the engine is switched OFF and a door is opened.
Approx. 30 seconds after disarming the system via electronic key.
A flashing LED indicates an armed condition; the vehicle can no longer be started.
To disarm the system, touch the electronic key to its receptacle; the LED will
stop flashing to indicate the system has been disarmed.
!
!
!
