+
!
ATTENTION
14.0 -
:
).
.
.
!
!
!
SYSTEM CONFIGURATION
After wiring connections are completed, activate and configure the system as
follows
Make sure the SIM card is properly inserted and power the system
(reconnect the battery negative pole
Move the vehicle outside for better satellite reception
Turn ignition key ON for approx.1 minute to get valid GPS data
If you are unsure whether the first initialization has been done correctly,
repeat the operation by disconnecting the module and reconnecting it after
a few minutes.
15.0 -
MyGTRACK systems are electronic devices which require suitable installation
and maintenance.
Fit the unit in a horizontal position respect to the vehicle axis, in a well-
hidden area inside the vehicle cabin.
The module must be installed away from heat sources and potential water
infiltrations.
Only use manufacturer-specified voltages.
Do not clean the unit with water but use a damp cloth to wipe.
Do not remove warranty labels.
GEMINI TECHNOLOGIES S.p.A. DECLINES ANY LIABILITY FOR
DAMAGES TO THE SYSTEM DUE TO IMPROPER USE OR INSTALLATION.
!
!
!
!
!
CONTROL UNIT INSTALLATION AND MAINTENANCE
If the system has been properly initialized, remotely configure the system as
follows
Turn ignition key OFF.
Send an SMS with the configuration string to the phone number of the SIM
card installed in the unit (see chapter 5.0 and 8.0).
If correctly configured, you will receive a confirmation SMS; otherwise you
will receive an error message.
!
!
!
: