!
ATTENTION
3.0 - ALARMS
3.1 - POSITION ALARM
system disarmed
The system
(
) and the
.
.
alarm
The
allows
provides protection against displacement attempts of the vehicle
when ignition is turned OFF ex. towing
When ignition is switched back ON, the system compares the current position
with the position recorded upon last switch-off
If they differ (value above the normal tolerance factory set by Gemini and
unalterable), the system will send the user an
message.
P.P.C. function (par. 5.10)
tracking vehicle position while the
.
system
is armed
This alarm is only triggered if the “system arming” command
has been previously sent
on#password#
aux#password#n
(par. 5.11 or 8.0) or if the system
has been armed via the
command (par. 5.14 or 8.0).
If someone breaks in the vehicle while the system is armed and attempts to
turn ignition ON
sends an alarm message.
After the message is sent to the 1st preset number, the system checks the
alarm source. If still active, it will be inhibited (ex. ignition key ON). If not active
(ex. ignition key OFF) it will be restored to guarantee protection once again.
, the system
The
n alarm message will be sent if
system rovides protection against severing the battery connection to the
alarm unit. An alarm will be triggered and a
power supply is cut-off.
p
3.2 - START ALARM
The “last valid position” is the vehicle last recorded position (lat., long.,
time and date) when ignition key is turned OFF.
The recorded position remains unvaried until ignition is turned back ON or
in case of an alarm or if the “periodic position control” command is
activated (the last two conditions are only available if the system is
armed).
!
ATTENTION
3.3 - BATTERY TAMPER ALARM
!
ATTENTION
This alarm is only triggered if the “system arming” command
has been previously sent
on#password#
aux#password#n
(par. 5.11 or 8.0) or if the system
has been armed via the
command (par. 5.14 or 8.0).