!
ATTENTION
The system can be configured with the “STOP & GO” feature (SMS
message when ignition is turned ON or OFF, see par. 5.2, 5.3 or 8.0).
5.2 - STOP & GO ACTIVATION COMMAND :
5.3 - STOP & GO DEACTIVATION COMMAND:
5.4 - VEHICLE
5.5 - TRACKING COMMAND (VEHICLE MOVEMENT):
5.6 - SPEED CONTROL COMMAND:
setup#password#can#main phone number#new
password#emergency phone number#f#
setup#password#can#main phone number#new
password#emergency phone number#s#
loc#password#
trk#password#
speed#password#060
Upon reception of SMS, the system replies:
Every time ignition key is turned ON, user will receive the following SMS:
Key On GPS status; latitude; longitude; speed; time; date.
Every time ignition key is turned OFF, user will receive the following SMS:
Key Off GPS status; latitude; longitude; speed; time; date.
Upon reception of SMS, the system replies:
By sending this command, the user will no longer receive a
message every time ignition is turned ON or OFF.
After the request, the system replies: system status (armed or disarmed), GPS
status; latitude; longitude; speed; time; date.
After the request, the system sends 6 SMS (approx. 1 every 90 seconds,
the 1st one to the sender and the other 5
),
indicating: GPS status; latitude; longitude; speed; time; date.
Code “060” indicates speed expressed in km/h. If this speed is exceeded for
more than 20”, the system forwards a speed alarm SMS (with vehicle position,
time, date, etc). When ignition is turned OFF, a 2nd SMS will be forwarded with
the maximum speed reached. If the maximum speed is exceeded for less than
20”, the system will only send an over speed alarm message when engine is
turned OFF. These messages are only sent to the 1st preset number.
To avoid receiving this message, set speed “000” (three zeros).
setup ok with password= new password.
Setup ok with password= new
password.
LOCATION COMMAND:
to the main preset number
