5.10 - PERIODIC POSITION CONTROL COMMAND:
5.11 - SYSTEM ARMING COMMAND:
5.12 - SYSTEM DISARMING COMMAND:
5.13 - SYSTEM STATUS REQUEST COMMAND:
pos#password#180
on#password#
off#password#
status#password#
This function is
available when the system is armed (by SMS or by
configuring the auxiliary input, see par. 5.11 and 5.14).
Code “180” indicates the number of minutes after which the system checks
vehicle position (selectable between 1 and 999 minutes). After the selected
time period (in this case 180 min.), the system checks vehicle position.
If the latter differs from the one previously recorded, an SMS will be forwarded
to both preset numbers (as in case of alarm SMS).
The message will ONLY be sent if ignition key remains OFF during the
selected period. If ignition is turned ON, countdown will start over again when
ignition is turned OFF.
To deactivate this function, set “000” (three zeros).
Upon request, the system will arm and send the user a confirmation message:
-System armed; GPS status; latitude; longitude; speed; time; date.
Upon request, the system will disarm and send the user a confirmation
message:
-System disarmed; GPS status; latitude; longitude; speed; time; date.
Upon request, the system will reply:
-System status (armed or disarmed); GPS status; latitude; longitude; speed;
time; date.
only
5.14 - AUXILIARY INPUT CONFIGURATION COMMAND:
aux#password#n
The letter “n” stands for any number from 0 to 7 (see table, par. 18.0).
This command is used to configure the auxiliary input according to
connections made by the installer.
Auxiliary input configuration should not be modified; ask your installer to show
you how to operate the system correctly.
