INTRODUCTION
Congratulations on purchasing the
GEMINI DISC-O-MIX 4.0
DJ Kit. Each piece of equipment
comes with instructions packed into the unit box. Prior to use, we suggest that you carefully read
the individual unit instructions included with your equipment.
DJ KIT FEATURES:
• Two CDJ-15 Instant Start Frame Accurate CD Players with Pitch Control
• One PMX-350 Two Channel Stereo Preamp Mixer
• DJC-1040 Road Case
• PM-100 Two-Way, Self Powered Monitor Speakers
• EM-50 Stereo Headphones
• GM-26 Professional Cardioid Microphone
• RCA Cables
CAUTIONS:
1. All operating instructions should be read before using this equipment.
3. To reduce the risk of electrical shock, do not open the units. There are
NO USER REPLACEABLE
PARTS INSIDE
. Please refer servicing to a qualified service technician.
4. Do not expose units to direct sunlight or to a heat source such as a radiator or stove.
5. The units should be cleaned only with a damp cloth. Avoid solvents or other cleaning detergents.
Do not use any spray cleaner or lubricant on any controls or switches.
6. When moving this equipment, it should be placed in its original carton and packaging. This will
reduce the risk of damage during transit.
7. Do not expose these units to rain or moisture.
NOTE: EXCESSIVE VOLUME CAN CAUSE DAMAGE TO YOUR STEREO SYSTEM AND SPEAKERS. KEEP VOLUME AT A
REASONABLE LEVEL.
CONNECTIONS:
Before making any connections, make sure all of the units have the power off. Before plugging in
the power cords, make sure that the
VOLTAGE SELECTORS
on the CD players are set to the
correct voltage (refer to the cd player instructions for more detail).
CD PLAYERS TO MIXER:
1. On the rear of the CD players are
RCA
output jacks. Using the
RCA
stereo cables provided,
connect the
LEFT
CD player to the
LN1/PH2
inputs on the rear of the mixer and move the switch
below the inputs to the
LN1
position.
2. Connect the
RIGHT
CD player to the
PH3/LN2
inputs on the rear of the mixer and move the switch
below the inputs to the
LN2
position. Set the
PH-1— PH-2/LN1
switch below the gain knob on the
face of the mixer to
PH-2/LN1
. Set the
PH-3/LN2— LN3
switch below the gain knob on the face of
the mixer to
PH-3/LN2
.
MIXER TO SPEAKERS:
1. On the rear of the mixer are
RCA
output jacks. Using the
RCA
stereo cables provided, connect the
mixer’s
MASTER
outputs to the
PM-100
speaker
INPUT
jacks on the rear of the right speaker.
2. Using the cable that is hard wired into the left speaker, connect the left speaker to the
L-SPK
jack
on the right speaker.
MIXER TO RECEIVER OR AMP:
1. The
MASTER
output jacks are used to connect the mixer to your main amplifier or stereo receiver
LINE
or
AUX
inputs using stereo
RCA
cables (included).
HEADPHONE/MIC:
1. Plug the
EM-50
headphone cable into the right front panel mounted
PHONES
jack.
2. Plug the
GM-26
mic cable into the
1/4" MIC
input (found on the left of the front panel).
SETUP DIAGRAM:
BACK OF SPEAKERS
BACK OF MIXER
IDEAL SETUP
