2
• Attach the hose to the vacuum cleaner by inserting it into the hose connector.
• Connect the two extension tubes. Fit the combined extension tube into the other end
of the hose, then attach the floor nozzle to the end of the tube.
• The special 2-in-1 nozzle provided as accessory inside the box are used for
particular vacuuming tasks, such as for furniture, in the car, and so on. Detach the
floor nozzle and fit the 2-in-1 nozzles to the end of the extension tube.
• Pull the cord out of the vacuum cleaner. The cord must not be pulled out any further
than the red mark label. Plug in and switch the power on.
• Press the on/off button to start and stop the vacuum cleaner.
• While in use, the suction strength can be regulated by opening and closing the air
valve on the handle at the end of the hose.
• The floor nozzle has two settings. When cleaning hard surfaces. the nozzle brushes
should be extended. When cleaning carpets and rugs, the brushes should be retracted
into the nozzle. Press the brush change button to switch between the two settings.
• If you need to pause to move furniture etc during vacuuming, you can place the floor
nozzle in the parking holder using the fixture on the back of the nozzle.
1. Floor Nozzle
2. Extension Tube
3. Airflow Valve
4. Soft Hose
5. Hose connector
6. Dust Bin
7. Dust Bin Release Button
8. Unit Handle
9. On/off Button
10. Dust Bin Unlock Button
11. Cord Rewind Button
12. Parking Holder
13. Air Outlet Grid
14. Accessory (2-in-1 nozzle)
PARTS DESCRIPTION
PREPARING THE VACUUM CLEANER
USE
1
2
3
4
5
6
7
8
12
13
9 10
11
14
