INPUTS:
Phono:..........................................................3 mV, 47 KOhm
Line:..........................................................150 mV, 27 KOhm
Mic 1, 2, & 3:................................1.5 mV, 1 KOhm Balanced
OUTPUTS:
Amp/Zone:................................................0 dB 1V, 400 Ohm
Max:.........................................................20V Peak-to-Peak
Rec:............................................................225 mV, 5 KOhm
GENERAL:
Frequency Response:........................20Hz - 20KHz +/- 2 dB
Distortion:..................................................................< 0.02%
S/N Ratio:.................................................Better Than 80 dB
Talkover Attenuation:..................................................-16 dB
Headphone Impedance:...........................................16 Ohm
Power Source:..............................115/230V, 50/60Hz, 20W
Unit Dimensions:..................................W 19" x H 3.4" x D 7"
...................................................(482.6 x 86.36 x 177.8 mm)
Weight:......................................................8.95 lbs (4.05 kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION FOR
IMPROVEMENT.
(6)
ON/OFF
(50) button begins blinking shortly indicating that the
DSP
effects are not engaged in
CUE MODE
. To engage the
DSP
, tap the
EFX ON/OFF
(50) button to engage the
DSP EFX
.
3.
PARAMETER:
To adjust the
PARAMETER
, or dynamics of
the effect signal, use the
PARAMETER
(52) rotary knob to
expand or minimize the effect level of the
DSP
effects. Rotate
this knob clockwise to expand the effect. Rotate this knob count-
er clockwise to minimize the effect.
4.
LCD:
The blue
LCD
(66) shows the
EFX
selection abbreviat-
ed name, to indicate which effect is activated or which effect
may be activated at the top part of the screen. While the bottom
part of the screen displays the
PARAMETER
level as controlled by
the
PARAMETER
(52) rotary knob.
5.
EFX SELECTOR:
Use the
EFX SELECTOR
(51) rotary knob
to scan through the
26 DSP
effects as indicated in the blue
LCD
(66) display. Once you have found an effect you would like to
engage, press the
EFX ON/OFF
(50) button to engage the
DSP
effect. The
EFX SELECTOR
(51) rotary knob can rotate
360
o
while scanning through the effects. Rotate the
EFX SELECTOR
(51) rotary knob clockwise to scan forward through the
EFX
list.
Rotate the
EFX SELECTOR
(51) rotary knob counterclockwise
to scan backwards through the
EFX
list. The effects are listed on
page 16.
NOTE: WHEN SCROLLING THROUGH THE EFFECTS YOU WIL FIRST SEE THE NUMBER
OF THE EFFECT, THEN THE LCD (66) WILL AUTOMATICALLY SWITCH THE VIEW TO THE
PARAMETER SETTING. THIS WILL AID IN SCROLLING TO AN EFFECT QUICKLY BY FIND-
ING THE NUMBER OF THE EFFECT.
SPECIFICATIONS:
