1.0 - TABLE OF CONTENTS
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
9.0
10.0
11.0
12.0
13.0
14.0
15.0
16.0
17.0
18.0
19.0
--.-
- TABLE OF CONTENTS
- PRELIMINARY ADVICE
- OPTICAL SIGNALS
- ALARM UNIT POSITIONING
- ACCESSORIES POSITIONING
5.1 - Status LED
5.2 - Contact switch (optional)
- SIM CARD
- ALARM UNIT SEALING
- PIN OUT TABLE
- WIRING DIAGRAM
- IMMOBILIZER WIRING DIAGRAMS
- DIODE INSTALLATION
- SYSTEM FEATURES
- ADDITIONAL INFORMATION
- SYSTEM CONFIGURATION
- PRE-ALARM AND ALARM
15.1 - Ignition attempt alarm
15.2 - Tilt alarm
15.3 - Position alarm
15.4 - Battery alarm
15.5 - Generic alarm (GREEN-BROWN wire connection)
15.6 - Perimeter alarm (wireless sensors)
- LEARNING NEW DEVICES
- WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
DIRECTIVE
- TECHNICAL SPECIFICATIONS
- AUXILIARY INPUT CONFIGURATION
R&TTE DECLARATION OF CONFORMITY
UK
2.0 - PRELIMINARY ADVICE
safety device
guarantee
protection
GPS localization and GSM communication
:
is
an integral part of the
system
!
!
!
)
Ignition (+15/54)
Topcase/seat contact switch (optional)
Dear installer,
The present GEMINI tracker is a
designed to
vehicle
via
(by mobile phone).
For proper operation, MAKE SURE ALL ELECTRICAL CONNECTIONS,
ESPECIALLY THE BASIC CONNECTIONS LISTED BELOW, ARE MADE IN
ACCORDANCE WITH THE MANUFACTURER’S WIRING DIAGRAM
Please read all instructions and understand them thoroughly before starting
installation.
The following signal words are used throughout this manual to emphasize
important instructions or special information.
Unit power supply (positive and ground
This manual
to be considered
tracking
and
must therefore accompany it for proper installation and use.
WARNING
!
Non-compliance to this instruction could result in serious damage to the
alarm system and the vehicle itself.
Non-compliance to this instruction may cause serious damage or
operational failures to the alarm system.
ATTENTION
Disable the PIN Code on the SIM Card in use.
If your service provider will not let you change it, insert the default code
“0000”.
ATTENTION
PAGE 1
