!
ATTENTION
5.7 - ENGINE STOP ACTIVATION COMMAND:
5.8 - ENGINE STOP DEACTIVATION COMMAND:
stop#password#
go#password#
At this request, the system sends a confirmation message to the sender.
When engine is cut-off (vehicle stopped with GPS speed zero) the system will
send an SMS, to both numbers, indicating engine stop and vehicle position
(latitude; longitude; speed; time; date.).
When engine stop is deactivated, the system sends an SMS to the user to
confirm operation.
5.10 - PERIODIC POSITION CONTROL COMMAND:
5.11 - SYSTEM ARMING COMMAND:
5.12 - SYSTEM DISARMING COMMAND:
5.13 - SYSTEM STATUS REQUEST COMMAND:
pos#password#180
on#password#
off#password#
status#password#
This function is only available when the system is armed (by SMS or by
configuring the auxiliary input, see par. 5.11 and 5.14).
Code
“
180
”
indicates the number of minutes after which the system checks
vehicle position (selectable between1 and 999 minutes). After the selected
time period (in this case 180 min.), the system checks vehicle position.
If the latter differs from the one previously recorded, an SMS will be forwarded
to both preset numbers (as in case of an alarm SMS).
The message will ONLY be sent if ignition key remains OFF during the
selected period. If ignition is turned ON, countdown will start over again when
ignition is turned OFF.
To deactivate this function, set
“
000
”
(three zeros).
Upon request, the system will arm and send the user a confirmation message:
- System armed; GPS ok; latitude; longitude; speed; time; date.
Upon request, the system will disarm and send the user a confirmation
message:
-System disarmed GPS status; latitude; longitude; speed; time; date.
Upon request, the system will reply:
-System status (armed or disarmed); GPS status; latitude; longitude;
speed;time; date.
5.9 -
):
pol#password#045
Code
“
045
”
indicates the number of days after which the system will send a
message referring its status (selectable between 1 and 999 days).
This message is only forwarded to the 1st preset number and is useful to avoid
expiry of SIM card.
If no calls or recharges are made over a certain period, your provider could
block the SIM card. Check your price plan and recharge your card balance if
necessary.
To deactivate this function, set value
“
000
”
(three zeros).
SIM VALIDITY CHECK COMMAND (FREQUENCY
Engine stop can ONLY be deactivated with an SMS.
This message is only sent if engine is turned ON (ignition key ON).
Therefore, if the module does not detect ignition or if the periodic position
control command is not configured, no message will be forwarded even if
the preset time period has elapsed.
!
ATTENTION
5.14 - AUXILIARY INPUT CONFIGURATION COMMAND:
aux#password#n
The letter
“
n
”
stands for any number from 0 to 7 (see table, par. 18.0).
This command is used to configure the auxiliary input according to the
connection made by the installer.
Auxiliary input configuration should not be modified; ask your installer to show
you how to operate the system correctly.
